Turning On The Movie Camera And Selecting Modes; Using The Viewfinder; Using The Lcd Monitor - Panasonic NV-MX350B Operating Instructions Manual

CAMERA
VCR
CARD P.B
1, 2
MODE
ON
OFF
3
1
1 2
1
12:30:45 12:30:45
12:30:45 12:30:45
15.10.2002 15.10.2002 15.10.2002 15.10.2002
2 3
180x 90x
Turning on the Movie Camera and Selecting
Modes
Turn on the power first and then select modes.
How to Turn on the Power
ª
1
Slide the [OFF/ON/MODE] Switch to [ON] while pressing the
centre button
≥The [CAMERA] Lamp lights up.
How to Switch Modes
ª
2
Slide the [OFF/ON/MODE] Switch.
≥With each slide of the Switch, the Mode switches in the order of Camera
Mode, VCR Mode, and Card Playback Mode.
≥The appropriate Mode Lamp lights up.
How to Turn off the Power
ª
3
Slide the [OFF/ON/MODE] Switch to [OFF] while pressing the
centre button
~~~~~~~~~~~~~~~~~~~~~~~~~

Using the Viewfinder

Before using the Viewfinder, adjust the field of view so that the displays inside
the Viewfinder become clear and easy to read.
1
Tilt the Viewfinder upward.
≥The Viewfinder can also be pulled out for use.
≥Do not pull on the Eyecup to extend the Viewfinder.
2
Adjust by sliding the Eyepiece Corrector Knob

Using the LCD Monitor

With the LCD Monitor open, you can also record the picture while watching it.
1 1 1 1
Press the [PUSH OPEN] Button and, at the same time, bring
the LCD Monitor out about 90
≥The Viewfinder goes off.
2 2 2 2
Adjust the LCD Monitor angle according to the desired
recording angle.
≥The LCD Monitor can rotate a maximum of 180o
PUSH
OPEN
position to the upward direction and a maximum of 90o
downward direction. Forcefully rotating the LCD Monitor beyond these
ranges will damage the Movie Camera.
Closing the LCD Monitor
Push the LCD Monitor until the [PUSH OPEN] Button is securely locked.
Adjusting Brightness and Colour Level
ª
When [LCD/EVF SET] on the [DISPLAY SETUP] Sub-Menu is set to [YES],
the following items are displayed. ( l 12)
LCD Brightness [LCD BRIGHTNESS]
It adjusts the brightness of the image on the LCD screen.
LCD Colour Level [LCD COLOUR LEVEL]
It adjusts the colour saturation of the image on the LCD screen.
Brightness of the Viewfinder [EVF BRIGHTNESS]
It adjusts the brightness of the image in the Viewfinder.
To Adjust
Press the [PUSH] Dial and select the item to be adjusted, and then turn the
[PUSH] Dial to raise or lower the number of vertical bars in the Bar Indication.
≥A larger number of vertical bars indicates stronger brightness or colour
saturation.
Increasing the Brightness of the Entire LCD Monitor
Set the [LCD MODE] on the [DISPLAY SETUP] Sub-Menu to [BRIGHT].
≥These adjustments do not affect the recorded images.
≥For other notes concerning this item, see page 58.
1
.
1
.
o in the direction of the arrow.
1
.
2
from the vertical
3
to the
11