Table of Contents
Advertisement
LUBRICATION
GUIDE
(International Cub Cadet 105 and 125 Tractors)
--After
Every
10 Hours
of Operation
1. Oil filler
cap and bayonet-type
ail level gauge.
Check the oil (with the engine
stopped)
and add sufficient
new oil to bring
it to the "FULL"
mark
on the gauge.
Do
not overfill.
Do not operate
the engine
if the oil level
is
below the "LOW"
mark
on the gauge.
Use IH-25lH
EP grease
or equivalent
#2 multi-purpose
lithium
grease
and apply
sufficient
grease
to flush
out old
grease
and dirt.
2. Steering knuckles (2).
3. Front axle pivot pin.
Note: After
the first
10 hours
only, remove
the old filter
and replace
with a new filter
as instructed
on page 30.
Change
the oil filter
after
50 hours
and every
100 hours
of operation
thereafter.
4. Transmission ail filter,
--After
Every
30 Hours
of Operation
While
the oil is warm,
remove
the drain
plug (5) and
drain
all of the oil from
the crankcase.
Replace
the drain
plug.
Remove
the crankcase
oil filler
cap (I).
Refill
the
crankcase
with new oil up to the "FULL"
mark
on the oil
level
gauge.
Refer
to the "Lubrication
Table"
for the
proper
quantity
and viscosity
to use.
S. Engine crankcase.
--After
Every
50 Hours
of Operotion
Note: After
the first
50 hours
only, remove
the old filter
and replace
with a new filter
as instructed
on poge 30.
Change the oil filter
every
100 hours
of operation
thereafter.
6. Transmission oil filter.
.
--After
Every
100 Hours
of Operation
7. Transmission oil filter.
Change
the oil filter
and replace
with a new filter
as
instructed
on poge 30.
--Periodi
c
Transmission
Check the oil level periodically.
Keep the lubricant
up to
the level
plug (8) on the rear
of the transmission
case
cover.
8.
Oil level and filler plug.
34
Advertisement
Table of Contents
