Table of Contents
Advertisement
Removing Interference / Changing RF-channel
TV screen
The picture with interference
VCR Ch:28
On-Screen Display
Test pattern indication
VCR display
Indication when the RF output
channel is 28 (example)
Indication after changing the RF
output channel to 31 (example)
VCR Ch:31
Test pattern indication
The clear picture
In some cases, interference (lines or patterning) or a very poor picture may
appear on the TV when the VCR is connected. If this happens, follow the
steps below to change the video playback channel (RF output channel) to
remove the interference.
!
Set the
VCR/TV
!
Press the
MENU
output channel number is displayed on the VCR display.
!
Press the
Numeric
to select a channel number, which differs by 2 or 3 from the
present channel number. (For example, if the original
channel number was 28, enter 31.)
!
Retune your TV until you receive the Test pattern. It may be
necessary to repeat steps 2 and 3 above until you can see the
Test pattern clearly. If using a Scart cable please see the note
below.
!
Press
ENTER
-
Note:
Set the RF output channel of the VCR to [- -] (RF OFF) if the VCR is
connected to the TV via the 21-pin Scart cable.
-
Press the button or Channel button to
0
21-pin Scart cable.
switch to VCR.
button for more than 5 seconds.
buttons or use the Channel
to finish this setting.
display [- -], if using a
...
21
68
(RF OFF)
VCR
TV
MENU
The RF
(CH)
button
TRACKING/V-LOCK
CH
19
Advertisement
Chapters
Table of Contents
