Charge Battery - Siemens ST60 Operating Instructions Manual

ST60 english retail, A31008-H6855-A101-1-7619 (11. December 2003,

Charge battery

The battery is not fully charged
when delivered. Plug charger cable
into the bottom of the phone
plug the charger cable into a mains
power socket and charge for at least
2.5 hours.
1
2
To remove, push the buttons on the
side of the connector in the direction
2
of the arrows .
Charging time
An empty battery is fully charged
after about 2.5 hours. Charging is
only possible within a temperature
range of +5 °C to +40 °C. The mains
voltage specified on the power sup-
ply unit must not be exceeded.
Getting started
Charge icon not visible
If the battery has been discharged
fully the charge icon is not immedi-
ately visible when the charger is
1
,
plugged in. It will appear after up to
2 hours. In this case the battery is
fully charged after 3-4 hours.
Please only use the power supply unit
provided!
Display while in service
2
Charge level display during opera-
tion (empty – full):
A beep sounds when the battery is
nearly empty. The charge level of the
battery is only displayed correctly
after an uninterrupted charging/dis-
charging cycle. You should therefore
not remove the battery unnecessarily
and where possible not finish the load-
ing process early.
Additional information
The charger heats up when used for long
periods. This is normal and not dangerous.
Operating time
A full battery will deliver up to
140 hours of standby time or
270 minutes of talktime (p. 78).
9