KitchenAid KGCT366E Use & Care Manual page 10

REMOVING A SURFACE BURNER & SPARK IGNITOR
Tools Required:
1/4 " Nut Driver
1/2 " Open End Wrench
3/8 " Open End Wrench
1. Turn off the gas and the electrical supply to the cooktop.
2. Remove the gas regulator and remove the cooktop from the cabinet.
3. Turn the cooktop over and remove the burner box cover (see page 3).
Refer to the illustration on the next page.
4. Disconnect the spark ignitor wire from the pin for the surface burner you wish to
service.
5. Disconnect the gas line fitting from the surface burner that you wish to remove, and
remove the hex-head screw from the surface burner bracket , then remove the burner
and mounting plate from the cooktop glass.
6. Unclip the spark ignitor and remove it from the surface burner, then remove the three
hex-nuts from the surface burner and remove it from the plate.
7. Reassemble the unit.
- 6 -