Error Messages - Martin MAC 250 ENTOUR User Manual

E
RROR MESSAGES
Display readout
(Memory error)

or
 
 (Color wheel time-out)
 (Rotating gobo time-out)
(Fixed gobo time-out)

 (Gobo indexing time-out)




(head temperature cutoff)





Appears if...
...the EEPROM memory cannot be
read.
... there is no communication between
the control panel and motherboard.
This appears briefly when switching on
the fixture.
...the magnetic-indexing circuit
malfunctions (e.g. sensor defective or
magnet missing).
...the software doesn't detect any
pulses from the light sensor for a
specific period of time.
...the lamp cannot be struck.
....there is a short circuit and the lamp
is struck without a command.
...the temperature in the base is too
high
...the temperature in the head is too
high
...if there is a pan error and the sensor
cannot find the pan index point
...if there is a tilt error and the sensor
cannot find the pan index point
...if there is a drive current error.
...if there is a display programming
error.
Table 7: Error messages

Error messages

What to do
• Contact service technician.
• Check fuses.
• Check cable between control panel
and motherboard.
• Reinstall software.
• Contact service technician.
• After the time-out, the effect in ques-
tion stops in a random position.
• Contact service technician.
• Ensure that the light sensor cable is
mounted correctly on the PL54 con-
nector. If it is, the light sensors may
be defective.
• Replace the lamp
• Contact service technician.
• Check that fans are clean and work-
ing. Clean fixture if necessary
• Check that the ambient temperature
does not exceed 40° C (104° F)
• Contact service technician if the
problem persists.
• Check that fans are clean and work-
ing. Clean fixture if necessary
• Check that the ambient temperature
does not exceed 40° C (104° F)
• Contact service technician if the
problem persists.
• After the time-out, the fixture stops in
a random position.
• Contact service technician.
• After the time-out, the fixture stops in
a random position.
• Contact service technician.
• Contact service technician.
• Contact service technician.
45