Low Engine Power; Engine Not Running Smoothly - Central Machinery 96549 Assembly And Operation Instructions Manual

symptom
When pressing Throttle
for higher speed, engine
responds slowly; speed is
decreased; or engine stops.
Symptom
Engine pinging.
Abnormal combustion.
Spark plug not firing
correctly
Engine stops suddenly.
SKU 96549

low engine power

probable cause
Incorrect Ignition timing.
Fuel supply problem:
1. Fuel line is clogged or has air
2. Main jet not adjusted properly
3. Carburetor needle valve hole
and main jet clogged
4. Gas valve clogged
5. Carbon buildup in combustion
chamber.
6. Air filter is clogged.
7. Intake pipe leaking.
Low compression:
1. Piston, piston ring, or cylinder
worn.
2. Air leakage from surface where
cylinder block contacts cylinder
head.
3. Valve clearance incorrect.
4. Valve tightness poor.

engine not running smoothly

Probable Cause
1. Piston, ring, or cylinder worn.
2. Piston pin and pin hole are
worn excessively.
3. Tie rod small head is worn.
4. Main crankshaft roller bearing
worn.
1. Engine too hot.
2. Carbon fouling in combustion
chamber.
3. Wrong gasoline type.
1. Water in carburetor float
chamber.
2. Spark plug electrode gap
wrong.
3. Incorrect ignition timing.
4. Ignition coil malfunction.
1. Gas tank empty.
2. Carburetor clogged
3. Floater is leaking.
4. Needle valve sticks.
5. Spark plug dirty or damaged.
6. Spark plug connector wire
damaged or disconnected.
7. Low oil auto-shutdown.
8. Ignition coil damaged.
9. Cylinder or valve damaged.
for technical questions, please call 1-800-444-3353.
possible remedy
Re-adjust ignition advance angle.
1. Clean line. Bleed line of air.
2. Readjust jet.
3. Clean needle valve hole and
main jet
4. Clean or replace gas valve.
5. Clean combustion chamber.
6. Clean filter elements.
7. Repair or replace.
1. Replace damaged part.
2. Replace cylinder gaskets.
3. Adjust valve.
4. Repair or replace valve.
Possible Remedy
1. Replace worn part.
2. Replace piston and/or pin.
3. Replace tie rod.
4. Replace roller bearing.
1. Troubleshoot overheating (see
page 11).
2. Clean chamber.
3. Drain gas from system and
replace with correct type.
1. Clean Carburetor.
2. Adjust spark plug gap.
3. Re-adjust.
4. Repair or replace coil.
1. Fill gas tank.
2. Clean carburetor and check
fuel line.
3. Repair or replace.
4. Disassemble floater chamber
and clean.
5. Replace spark plug.
6. Check and repair spark plug
wire.
7. Fill with oil.
8. Repair or replace.
9. Disassemble, check, and
repair.
Page 10