Table of Contents
Advertisement
Quick Start Guide
1
Connection and setting up options
Please ensure that the unit is disconnected from the mains
before attaching or disconnecting any leads.
AV1
DCIN 15V
Scart Connections
• The VCR / DVD Recorder can be connected to the TV using a Scart cable, if you are using a Scart equipped
VCR / DVD Recorder.
• Use the TV's any Scart terminal for any VCR / DVD Recorder. Always use a "fully wired" Scart cable.
• Use the TV's AV1 Scart terminal for Satellite Receiver. Always use a "fully wired" Scart cable.
RF Connection
• Connect the RF cable to the "Aerial In" terminal of the VCR / DVD Recorder and an RF cable from the VCR
/ DVD Recorder "Aerial Out" terminal to the TV Aerial terminal (
Notes:
• Further details of Audio / Video connections can be found on page 24, 25.
• Additional equipment and cables are not supplied.
2
Connect the TV to AC adapter and its
mains plug to the wall sock et.
Press the
switch on the TV set to turn
the set on.
To switch the TV set to Standby mode, press
the
button on the remote control.
The TV set can be switched on by pressing
the
button again if it was in Stand by
mode.
Note:
This TV will still consume some power as
long as the mains plug is still inserted into
the wall socket.
Remote control signal sensor
Power Indicator
Standby : Red
On : No Light
AV2
RGB
VIDEO
S-V
R
L
V
AV1
AV2
RGB
VIDEO
S-V
R
L
V
Scart cables (Not supplied)
RF cable (Not supplied)
DCIN 15V
SET TOP BOX
VCR / DVD
Recorder
).
DCIN 15V
AV1
AV2
RGB
VIDEO
S-V
R
L
V
STR
F
TV/AV
RF cable
(Not supplied)
OK
N
1
2
3
4
5
6
7
8
9
C
0
TV
5
Advertisement
Table of Contents
