Pioneer HTZ-929DVR Setup Manual

HTZ-929DVR Setup guide
1 Connect the DVD-RW/HDD Tuner to the powered subwoofer
CAUTION:
When Powered subwoofer
connecting this system or
changing connections, be
sure to switch power off
and disconnect the power
cable from the wall socket.
Only after completing all
connections, connect the
power cable to the wall
socket.
12-pin system cable A (blue plugs)
16-pin system cable B (black plugs)
Connect the speakers to the powered subwoofer
2
Please also see the S-DVR9ST Speaker setup guide.
a Each speaker cable, speaker and terminal on the
powered subwoofer is color coded. Connect the colored
Gray
side of each speaker wire to the colored terminals; the
Surround right
other side to the black.
Push the terminal tab to open; insert the wire, making
sure there are no stray strands. Release the tab to secure
the wire.
Gray
b Connect all the speakers in the same way.
Front right
Red
AC IN
R L CENTER
FRONT
Red
(please complete the S-DVR9ST Speaker setup guide first)
Assembling the AM loop antenna
a Bend the stand in the
direction indicated by the
arrow.
AM loop antenna
b Clip the loop onto the
FM wire antenna
stand.
If you want to fix to a wall or
other surface, perform this
step after first securing the
stand with screws.
c It is recommended that
you determine the reception
strength before securing the
stand with the screws.
DVD-RW/HDD Tuner
CAUTION:
Do not connect the supplied speakers
to another amplifier or system. This could damage
the speakers, or result in fire.
CAUTION:
These speaker terminals carry
HAZARDOUS LIVE voltage. To prevent the risk of
electric shock when connecting or disconnecting
the speaker cables, disconnect the power cord
before touching any uninsulated parts.
Before connecting, twist
off the protective shielding
on each end.
White
Gray
Blue
Green
RS LS
SPEAK
SURROUND
R L CENTER RS LS
FRONT SURROUND SPEAK
Red
Green
3 Connect the DVD-RW/HDD Tuner to your TV and VCR
IMPORTANT:
Do not connect the DVD-
RW/HDD Tuner to your TV via a VCR. Due to
copy-protection technology the picture may
be distorted. Always connect the DVD-
RW/HDD Tuner directly to your TV.
Connecting the DVD-RW/HDD tuner
a Connect the supplied yellow video cable to
the MONITOR OUT VIDEO jack on the DVD-
RW/HDD tuner and a video input on your TV.
If you're not connecting
b Connect the antenna/cable TV wall outlet to
a VCR, connect the RF
the VHF/UHF ANTENNA IN connector on the
antenna cable from the
DVD-RW/HDD tuner.
antenna/cable TV wall
outlet directly to the
c
Use an RF antenna cable to connect the
DVD-RW/HDD Tuner.
VHF/UHF ANTENNA OUT connector on the
DVD-RW/HDD tuner to the antenna input on
your VCR (or directly to your TV if you're not
connecting a VCR).
Connecting your VCR
d Use a three-way RCA audio/video cable to
connect your VCR to the LINE 3 IN AUDIO and
VIDEO jacks.
Use an RF antenna cable to connect the
e
antenna output of your VCR to the antenna
input on your TV.
NOTE:
You can find details of other
connections in chapter 16 of the main
Operating Instructions.
Blue
Surround left
Blue
Front left
Green
Center
Antenna in
e
TV
Antenna out
Antenna in
VCR Audio/Video out
c
d
COMPONENT S - VIDEO S - VIDEO AUDIO IN OUT S - VIDEO VIDEO R AUDIO L
VHF/UHF ANTENNA L L
LINE3
OUT SCREW IN Y
MAX4mm IN IN
LINE OUT
P B OUT
R R
VIDEO VIDEO R L
S - VIDEO VIDEO AUDIO
LINE1 IN
P MONITOR ANALOG AUDIO
R ( AUTO START REC )
OUT
IN
FM UNBAL AM
75Ω LOOP
AM/FM ANTENNA OUT IN 1 IN 2
USE ONLY WITH S-DVR9 SW
CONTROL OPTICAL DIGITAL AUDIO
b
Plug in
4
Connect the supplied power cables to the AC IN sockets of the DVD-RW/HDD tuner and subwoofer units.
Connect the power cables to a wall socket.
White
POWER CORD CAUTION:
the plug. Do not pull out the plug by tugging the cord and
never touch the power cord when your hands are wet as
this could cause a short circuit or electric shock. Do not
place the unit, a piece of furniture, etc., on the power
cord, or pinch the cord. Never make a knot in the cord or
tie it with other cords. The power cords should be routed
such that they are not likely to be stepped on. A damaged
power cord can cause a fire or give you an electrical
shock. Check the power cord once in a while. When you
find it damaged, ask your nearest Pioneer authorized
service center or your dealer for a replacement.
If the AC plug of this unit does not match the AC outlet you
want to use, the plug must be removed and appropriate one
fitted. Replacement and mounting of an AC plug on the
White
power supply cord of this unit should be performed only by
qualified service personnel. If connected to an AC outlet, the
cut-off plug can cause severe electrical shock. Make sure it
is properly disposed of after removal.
The equipment should be disconnected by removing the
mains plug from the wall socket when left unused for a long
period of time (for example, when on vacation).
D3-4-2-2-1a_A_En
Video in
a
AC IN
Antenna/cable TV
wall outlet
Handle the power cord by
<ARE7350-A>