Front Panel Functions - Pioneer ELITE PRO-620HD Operation Instruction Manual

FRONT PANEL FUNCTIONS

A flip-down door conceals the INPUT 4 jacks. Push gently and
release, to open the door. To close the door, lift it back up into
place.
NOTE:
If you accidentally pull the door, it may not shut properly. Push
the door back in to shut it.
P U S
H
1
STANDBY ON
20
In some cases, the door may only open slightly when pushed.
In such cases, open the door with your finger as shown in the
figure at left.
2
ROOM LIGHT
SENSOR
1 POWER STANDBY/ON indicators
red: STANDBY
green: ON
2 ROOM LIGHT SENSOR (RLS)
Sensor to detect the room brightness.
3 MAIN POWER
If the button is OFF, the power of the monitor is shut off and 4
STANDBY/ON button on the receiver or TV power on the
remote control will not function. Pressing the button again
will turn the monitor ON and the monitor enters the standby
mode. In the standby mode, you can turn on the monitor using
the 4 STANDBY/ON button on the monitor or TV power on
the remote control.
4 POWER ( STANDBY/ON) button
Switches the monitor between on and standby (note that the
monitor consumes a small amount of power (0.3 W) in standby
mode.
5 INPUT SELECT button
Press to select your program source. Each press of the INPUT
SELECT button changes the selection to the next source.
TV
INPUT 4
While the menu is displayed, it performs the same operation
as the SET/ENTER button on the remote control.
6 CHANNEL buttons
Press plus (+) or minus ( – ) to tune to a higher or lower channel.
Only the preset channels can be tuned in using these buttons.
3 4
MAIN POWER
STANDBY/ON
POWER
(OFF/ON) button
INPUT 1
INPUT 3 INPUT 2
5 6 7
SELECT
INPUT CHANNEL RETURN