Panasonic Viera TX-P37X20B Operating Instructions Manual page 70

FAQs
Sound is unusual
Pictures from external
equipment are unusual
when the equipment is
connected via HDMI
The TV does not switch On
The TV goes into Standby mode
The remote control does not work
or is intermittent
Parts of the TV become hot
Permanently lit spots on screen
An error message appears
70
Problem
●
Set the sound setting of the connected equipment to
"2ch L.PCM".
●
Check the "HDMI1 / 2 / 3 Input" setting in the Sound Menu. (p. 29)
●
If digital sound connection has a problem, select analogue sound
connection. (p. 67)
●
Check the HDMI cable is connected properly. (p. 62)
●
Turn the TV and equipment Off, then turn them On again.
●
Check an input signal from the equipment. (p. 67)
●
Use an equipment compliant with EIA/CEA-861/861B.
●
Press and hold the standby On / Off switch on the remote control
for about 1 second if Power LED is red.
●
Check the mains lead is plugged into the socket outlet.
●
The fuse in the mains plug may have blown. Replace it with one of
an identical rating (p. 4).
●
Auto power standby function is activated. (p. 9)
●
The TV enters Standby mode about 30 mins. after analogue
broadcasting ends.
●
Are the batteries installed correctly? (p. 6)
●
Has the TV been switched On?
●
The batteries may be running low. Replace them.
●
Point the remote control directly at the front of the TV (within about
7 m and a 30 degree angle of the front of the TV).
●
Situate the TV away from sunshine or other sources of bright light
not to shine on the TV's remote control signal receiver.
●
Even when the temperature of parts of the front, top and rear
panels has risen, these temperature rises will not pose any
problems in terms of performance or quality.
●
Due to production process involved in this technology this may
result in some pixels which are permanently lit or unlit. This is not a
malfunction.
●
Follow the message's instructions.
●
If the problem persists, contact your local Panasonic dealer or the
authorized Service Centre.
Actions