U.S. General 65204 Set Up And Operating Instructions Manual page 13

Deflection
distance
2. Press on the center of the longest
span on each belt with moderate
finger pressure (4-4.5 lb.). Then
measure the deflection distance, the
distance that the belt moved. The
belt should deflect anywhere from
1/4" to 1/2".
Engine Mounting Bolts
If the belts deflect too much,
3.
tighten belts by loosening the en-
gine mounting bolts and moving the
engine away from the other pulley
slightly. Secure engine mounting
bolts and retest tension. If either belt
is too long to be properly tensioned,
both belts must be replaced.
4. If the belts deflect too little,
belts by loosening the engine mount-
ing bolts and moving the engine
towards the other pulley very slightly.
Secure engine mounting bolts and
retest tension.
5. Align pump and engine pulleys using
a straight edge to reduce noise and
vibration.
6. Before use, replace belt cover.
For technical questions, please call 1-800-444-3353.
SKU 65204/
99918
loosen
Page 13