Setting The Clock; Radio Reception; Setting The Alarm Time; Switching The Alarm Function On - Silvercrest KH 2187 Operating Instructions Manual

Setting the clock

When you take the device into use for the first
time after inserting a new battery:
Whilst pressing and holding the button
• Repeatedly press, or press and hold, the button
HOUR
y
to set the hours.
HOUR
y
• Release the
hour indicator is shown in the display
• Repeatedly press, or press and hold, the button
MIN MINUTE
u
resp.
MIN
• Release the resp.
as the required minute indicator is shown in the
display f .
The programmed time setting is automatically accepted
TIME
as soon as the button

Radio Reception

• Place the slider switch
• Ensure that the switch
RADIO
position .
• Turn the volume regulator
• Select the radio frequency range by using the
waveband selector
• Now select the desired radio station by turning
TUNING
the regulator
Note:
To improve reception in the FM frequency range,
slowly move and hold the end of the wire aerial
in various directions. When you have found the
best reception for the desired transmitter, fix the
wire aerial into this position e.g. with adhesive
tape. For the reception of AM transmitters, an aerial
is built into the device. For improved reception,
alter the position of the device in radio mode.
TIME
s
button as soon as the required
f
.
to set the minutes.
MINUTE
u
button as soon
s
is released.
ON
h
at the position
RADIO/ALARM j
is at the
g
to a midway position.
BAND
k
.
l
.

Setting the alarm time

When the correct time has been programmed in as
described above, proceed as follows:
: Whilst holding the button
• Repeatedly press, or press and hold, the button
HOUR
y
to set the hours.
• Release the
hour indicator is shown in the display
• Repeatedly press, or press and hold, the button
MIN MINUTE
resp.
• Release the
as the required minute indicator is shown in the
display f
The programmed alarm setting is automatically
accepted as soon as the button
released.

Switching the alarm function on

.
If the clock and alarm time are set correctly, as
described above:
• Place the slider switch
The alarm is now switched on. Serving as a check,
a dot appears in the left of the display
You will be woken by the radio if ...
• the volume regulator
level at which you will be woken.
• The switch
e
You will be woken by the signal tone if...
• The switch
ALARM .
- 5 -
AL. ON
o
pressed down:
HOUR
y
button as soon as the required
u
to set the minutes.
MIN MINUTE
u
resp.
.
AL. ON
h
in the position
g
is placed at a sound
j
RADIO/ALARM is at the position
j is at the position
RADIO/ALARM
f
.
button as soon
o
is
AUTO (AL.)
.
f
.
RADIO .