Panasonic Viera TX-P46Z1E Operating Instructions Manual page 92

FAQs
Cannot connect to the network
Cannot select the file during
DLNA operations
Cannot operate VIERA CAST
The TV does not switch On
The TV goes into
"Standby mode"
The remote control does not work
or is intermittent
Cannot operate the TV
Parts of the Display Unit or the
Tuner Box become hot
An error message appears
92
Problem
●
Check the LAN cable is connected properly. (p. 59)
●
Check the connections and settings. (p. 59 - 61)
●
Check the network equipment and network environment.
If the problem persists, consult your Internet Service Provider or
telecommunications company.
●
Is media server prepared? (p. 58)
●
Check applicable data format. (p. 58)
●
Check the connections and settings. (p. 59 - 61)
●
The server or connected line might be busy now.
●
Check the mains lead is plugged into the socket outlet.
●
Off Timer function is activated.
●
The TV enters "Standby mode" about 30 mins. after analogue
broadcasting ends.
●
Are the batteries installed correctly? (p. 8)
●
Has the TV been switched On?
●
Has the remote control been registered? (p. 79)
●
The batteries may be running low. Replace them.
●
Use the remote control within the range of 7 m from the Tuner Box.
●
Keep the remote control away from the devices such as wireless
LAN, microwaves, mobile phones or other electric equipment to
avoid radio wave interference.
●
Turn the Display Unit and the Tuner Box off, and then on again.
●
Check the transmission range of the Wireless Unit if you use it.
(p. 12)
If the problem persists, use the supplied HDMI cable to connect the
Display Unit and the Tuner Box instead of the Wireless Unit. (p. 12)
●
The temperature rises will not cause any problems in terms of
performance or quality.
●
Follow the message's instructions.
●
If the problem persists, contact the authorized Service Centre.
Actions