Panasonic Viera TX-26LE7FA Operating Instructions Manual page 28

FAQs
Chaotic image, noisy
No image can be
displayed
Blurry or
distorted image
(no sound or low volume)
Neither image nor
sound is produced
No sound is produced
Sound level is low
or sound is distorted
Sound is unusual
An error message
appears
"VIERA Link" function
does not work
TV unit goes into
"Standby mode"
An error message
appears
28
Problem
•
Set "P-NR" in the Picture menu (to remove noise).
(p. 14)
•
Check nearby electrical products
(car, motorcycle, fl uorescent lamp).
•
Is "Colour" or "Contrast" in the Picture menu set to the
minimum? (p. 14)
•
Reset channels. (p. 16)
•
Is the unit in "AV mode"?
•
Is the mains lead plugged into the socket outlet?
•
Is the TV unit turned On?
•
Check Picture menu (p. 14) and volume.
•
Is "Sound Mute" active? (p. 7)
•
Is the volume set to the minimum?
•
Sound signal reception may be deteriorated.
•
Set "MPX" (p. 14) in the Sound menu to "Mono".
•
Set the sound setting of the connected equipment
to "2ch L.PCM".
•
Check the "HDMI input" setting in the Sound menu.
(p. 14)
•
If digital sound connection has a problem, select
analogue sound connection. (p. 25)
•
Contact the authorized Service Centre.
•
Switch the TV unit on again with the equipment on.
•
Set "VIERA Link" to "Off", then set to "On" again. (p. 19)
•
The sleep function is activated.
•
The TV unit enters "Standby mode" about 30 min.
after broadcasting ends.
•
Follow the message's instructions.
•
If the problem persists, contact the authorized
Service Centre.
Actions