Cleaning The Shaver - Panasonic ES-LF71 Operating Instructions Manual

Cleaning the shaver

Use the self‑cleaning recharger in temperatures between 15 °C
and 5 °C.
1
1
Insert the appliance plug into
the self‑cleaning recharger.
2
2
Remove the protective cap and
then attach the shaver.
3
3
Plug in the AC adaptor into a
household outlet.
•
Remove any soap or water on the shaver if it has been washed
with hand soap or any other detergent.
•
Turn the shaver off before attaching.
• Check that the outer foil is not deformed or damaged when you
are attaching the shaver.
•
Wipe off any water droplets on the main body rear terminal.
4
4
Press the SELECT button to select the course.
•
The "Charge" course starts when attaching the shaver.
•
Each time you press the SELECT button, the course changes
from "Clean/Dry/Charge"
•
The courses start approximately 6 seconds after they are
selected.
• The course will be aborted if the power is cut off. In this case,
perform the course again from the beginning.
•
Do not detach the detergent cartridge or the water tank as the
cleaning liquid may spill causing a malfunction.

ES-LF71_EU.indb 8
3
2
1
"Dry/Charge" "Charge".
Course Time required (guide)
Charge
1 Charge
0 to 60 min
Clean
2 Clean/Dry/
Charge 10 min
•
It is not possible to change the course after the
"Clean/Dry/Charge" course has started.
Dry
3 Dry/Charge
10 min
•
It is possible to change to the "Clean/Dry/
Charge" course even after the "Dry/Charge"
course has started.
* When the ambient temperature of the self‑cleaning recharger is
low (approx. 15 °C or lower), the time it takes to dry the shaver
increases.
•
The Clean or Dry function may stop under extreme low
temperatures (approx. 0 °C or lower). In such a case, the CLEAN
and DRY lamps will blink when the "Clean/Dry/Charge" course is
selected, or the DRY lamp will blink when the "Dry/Charge"
course is selected.
Dry
Charge
0 min
0 to 60 min
(170 min*)
Charge
0 to 60 min
2011/03/03 11:44:29