Troubleshooting
Problem
The DVD player does not start playback.
Picture freezes momentarily during playback.
Unable to select Progressive Scan on/ off.
Images from this DVD player do not appear on
the television.
You forget your password.
When the following messages on the unit's
display.
(LOAD)
(STOP)
(OPEN)
(TITLE)
32
Solution
–
Insert a readable disc with the playback side
facing down.
–
Check the disc type, color system (PAL/NTSC)
and region code.
–
Check for any scratches or smudges on the disc.
–
Press SETUP to turn off the setup menu screen.
–
You may need to enter the password in order to
change the parental rating level or to unlock the
disc for playback.
–
Moisture may have condensed inside the system.
Remove the disc and leave the system turned on
for about an hour.
–
Disconnect the AC mains lead from the mains
socket for a few minutes. Reconnect the AC mains
lead and try to operate again as usual.
–
Check the disc for fi ngerprint/scratches and clean
with a soft cloth wiping from center to edge.
–
Check that the output of the video signal is turn to
{Progressive}.
–
Reset the DVD player to the factory defaults.
1)
Press 8 on the DVD player to turn it on.
Press OPEN/CLOSE ; to open the disc tray.
2)
3)
Press and hold g and q on the DVD player at the
same time for more than 5 seconds with the tray
open.
All the settings return to the factory preset.
–
Loading the disc. Wait a moment.
Stopping the playback. Press PLAY/PAUSE q/h.
–
–
Insert a readable disc with the playback side
facing down.
–
Press OPEN/CLOSE ; to close the tray.
Press e r w q to select the title, then press OK.
–