Panasonic Viera TX-L24C3E Operating Instructions Manual page 38

Set DVB channel manually [Manual Tuning]
Normally use [Auto Setup] or [Update Channel List] to retune DVB channels.
If tuning has not been done completely or for adjusting the direction of the aerial, use this function.
All channels found will be added to the Channel List.
DVB-C :
1
Enter the frequency
DVB-C Manual Tuning
Frequency
Symbol Rate
Service ID
Signal Quality
Signal Strength
No. Channel Name
Free TV: 0 Pay TV: 0
Stopped
DVB-T :
1
Adjust frequency for each channel
DVB-T Manual Tuning
Frequency
Signal Quality
Signal Strength
No. Channel Name
Free TV: 0 Pay TV: 0
Stopped
Update DVB channel automatically [Update Channel List]
You can add new channels, delete removed channels, update channel name and position automatically to Channel List.
DVB-T Update Channel List
Progress
This will take about 3 minutes.
CH Channel Name
Free TV: 0 Pay TV: 0
Searching
Display a notification message [New Channel Message]
Selects whether to give a notification message when a new DVB channel is found. [Off] / [On]
New channels found!
Press OK to update channel list.
Press EXIT to ignore.
Check DVB signal [Signal Condition]
Selects a channel and checks the DVB signal condition.
A good Signal Strength is not an indication of suitable signal for DVB reception.
Please use the Signal Quality indicator as follows :
[Signal Quality] :
Green bar Good
Yellow bar Poor
Red bar Bad (Check the Terrestrial aerial or cable)
DVB-C Signal Condition
Channel Name 70 CBBC Channel
Signal Quality
Signal Strength
Bit Error Rate 0.00E+00
Network Name Wenvoe
Parameter 802,00 MHz, 64 QAM, 6940 kS/s
Reduce the DVB-C signal [Attenuator]
If the DVB-C signal is too strong, the interference may occur. In this case set to [On] to reduce the signal automatically.
This function is available only for DVB-C signal.
38
abc
474,00 MHz ghi jkl
Auto
pqrs tuv
Auto
100%
100%
Normally set [Symbol Rate] and [Service
Type New
ID] to [Auto].
Radio: 0
[CH21] 474,00 MHz
100%
100%
Type New
Set where the level of [Signal Quality]
becomes the maximum.
Radio: 0 Data: 0
Channel List is updated while keeping your settings in [Favourites Edit],
CH 5 69
[Channel List], [Child Lock], etc.
Depending on the signal condition, the update may not work properly.
Type Quality
Radio: 0
Selecting OK will perform [Update Channel List].
90%
These bars show the maximum signal value of the selected channel.
80%
def
mno
wxyz
select channel
adjust frequency
2
Search
2
Search
To change the channel