Wind Noise Reduction Function; Using The Built-In Video Flash - Panasonic NV-GS250GC Operating Instructions Manual

Pause recording. (fade out)
The image/audio gradually disappears. After the
image/audio completely disappears, recording
stops.
ª
To cancel fading
Select the [ ] icon again.
ª To select the colour for fade in/out
The colour which appears in fading pictures can
be selected.
1
Set [SETUP] >> [FADE COLOUR] >>
[WHITE] or [BLACK].
≥While the fade in/fade out function is selected, it
takes several seconds to display the image
when you start recording images. Besides, it
also takes several seconds to pause recording.

Wind noise reduction function

This reduces the wind noise coming into the
microphone when recording.
≥Set to Tape Recording Mode.
1
Set [BASIC] >> [WIND CUT] >> [ON].
ª
To cancel the wind noise reduction
function
Set [BASIC] >> [WIND CUT] >> [OFF].
≥Reduces the wind noise depending on the wind
strength. (If this function is activated in strong
winds, the stereo effect may be reduced. When
the wind weakens, the stereo effect will be
restored.)
Record mode

Using the built-in video flash

Use the built-in video flash in order to record still
pictures in dark places.
≥Set to Tape/Card Recording Mode.
1
Set [ADVANCE] >> [FLASH] >> [ß] or [ßA].
≥If [ßA] is selected, then the video flash will
automatically flash as necessary.
2
Press the [PHOTO SHOT] button.
≥The video flash is activated and the picture
will be recorded.
≥You cannot use the built-in video flash unless
the card is inserted in the movie camera.
≥The movie camera, even when its video flash
has been turned off, automatically determines if
the flash is necessary by detecting the ambient
brightness. (If it determines that the flash is
necessary, the [
yellow.)
≥When the [ß] ([ßi]/[ßj]) indication or the [ßA]
([ßAi]/[ßAj]) indication is displayed, the video
flash can be lit. If the indication is flashing or not
displayed, the flash cannot be lit.
≥The available range of the video flash is approx.
1 to 2.5 metres in a dark place. Pictures will
appear dark or reddish when they are recorded
by using the video flash at distances greater
than 2.5 metres.
≥When set [FLASH] >> [ßA] and the shutter
speed, iris or gain is adjusted, the indication
(either [ßA], [ßAi], or [ßAj]) may disappear
and the video flash may not be lighted.
≥Using the video flash fixes the shutter speed of
1/750 s or faster to 1/500.
≥The picture may become out of focus in a dark
place. If so, adjust the focus manually.
≥The picture may appear dark if video flash is lit
in front of a white background.
≥A conversion lens (optional) can block the flash
and may cause a vignetting effect.
≥Do not use the flash with the ND filter (optional)
attached.
≥Set the flash to [
prohibited.
≥Do not block the flash by hand or any other
means.
ª
When the video flash is not used
Set [ADVANCE] >> [FLASH] >> [
PHOTO
SHOT
] indication lights up in
] where using a flash is
].
77
VQT0N70