Free Style Remote Control With Mic - Panasonic V-GS150GC Operating Instructions Manual

ª
Selecting the remote control mode
If 2 cameras are used simultaneously, set the
mode for one pair of movie camera and remote
control to [VCR1] and that of the other pair to
[VCR2]. This will prevent interference between
the 2 pairs. (The default setting is [VCR1]. When
the button-type battery is replaced, the setting will
revert to the default [VCR1].)
1
Setting on the camera:
Set [SETUP] >> [REMOTE] >> [VCR1] or
[VCR2].
2
Setting on the remote control:
STILL ADV
2
[VCR1]:
Press [D] and [∫] simultaneously. 1
[VCR2]:
Press [E] and [∫] simultaneously. 2
ª
Concerning the button-type battery
≥When the button-type battery runs down,
replace it with a new battery (part number:
CR2025). The battery is normally expected to
last about 1 year, but it depends on operation
frequency.
≥Keep the button-type battery out of the reach of
children.
≥If the remote control mode of the camera and
that of the remote control do not match with
each other, "REMOTE" will appear. When the
remote control is operated for the first time after
the camera is turned on, "CHECK REMOTE
MODE" ( ) will appear and operation is
-100-
impossible. Set the same remote control mode.
≥The remote control is intended for indoor
operation. Outdoors or under strong light, the
movie camera may not operate properly even
within the usable ranges.
≥Within a 1 metre range, you can operate the
remote control from beside the remote control
sensor (LCD monitor side) of the movie camera.
68
VQT0N45
VOL
PAUSE STILL ADV
1
STOP
VAR
Before using

Free style remote control with mic

This controller can be used from different high
and low angles. It is also handy when a tripod is
used. When you do not use the controller, attach
the clip to the grip belt. Left-handed users can use
this camera more easily.
(1) Microphone [MIC]
(2) Recording start/stop button [REC]
(3) Zoom lever [W/T]
(4) Photoshot button [PHOTO SHOT]
(5) Microphone switch button [TALK]
ª
Connect the free style remote control
with mic to the camera
1
Plug the free style remote control with mic
into the [REMOTE] terminal as far as it
goes.
ª
Switching the microphone
Press the [TALK] button on the free style remote
control with mic, and the microphone on the
remote control will be activated instead of that on
the camera.
≥While this button is being pressed, [
and the microphone on the remote control is
activated.
≥We recommend you talk with the microphone
approx. 10 cm away from your mouth.
(1)
(2)
(3)
(4)
(5)
REMOTE/MIC
] appears