Power Sources; Concerning The Remote Control - Panasonic RX-D27 Operating Instructions Manual

Using a household mains socket
FOR UNITED KINGDOM ONLY
READ THE CAUTION FOR THE AC MAINS
LEAD ON PAGE 3 BEFORE CONNECTION.
For areas except for
United Kingdom,
Continental Europe,
Australia and
VOLT ADJ
New Zealand
AC mains lead (included)
To household
mains socket
For areas except for United Kingdom,
Continental Europe, Australia and New Zealand
Set the voltage before connection.
Use a flat head screwdriver to turn [VOLT
ADJ] to the voltage setting for your area.
Note that the unit will be seriously damaged
or fail to operate correctly if this setting is
not made correctly.
Connect the AC mains lead firmly to the unit
and the outlet.
Note
• The included AC mains lead is for use with
this unit only. Do not use it with other
equipment.
• The unit is in the standby condition when the
AC power supply cord is connected.
The primary circuit is always "live" as long as
the power cord is connected to an electrical
outlet.
Battery installation
Insert the batteries (not included) observing the correct polarities ( , ).
1
4
RQTT0627

Power sources

Using batteries (not included)
The unit cannot be powered by batteries if the
AC mains lead is connected.
(R14/LR14, C, UM-2)
When to change the batteries
When the battery indicator begins flashing,
replace all 6 of the batteries. It is also a good
idea to replace all the batteries before recording.
Note
Before playing starts the battery indicator may
flash although the batteries are not drained. It
appears correctly once you start play.

Concerning the remote control

(R6, AA, UM-3)
2
Memory back-up
When the power supply is interrupted, the
current time, timer settings and radio stations
you have set are saved if you have inserted
back-up batteries (not included).
These batteries do not power the unit.
Inner row
Outer row
When to change the batteries
The batteries last about a year.
Connect the unit to AC power before replacing
the batteries.
Before connecting or disconnecting the AC
mains lead, press [TAPE/OFF] and stop the tape
to turn the unit off. The memory batteries are
worn out faster if the cord is disconnected with
the power still on.
Removing the batteries
Open the battery cover and insert your finger in
the hole on the bottom of the unit and push out.
For R6/LR6, AA, UM-3
Correct method of use
About 7 meters in front
of the signal sensor
Operation notes
• Do not place obstacles between the remote control signal sensor and
the remote control unit.
• Do not expose the remote control signal sensor to direct sunlight or to
the bright light of fluorescent light.
• Take care to keep the remote control signal sensor and end of the
remote control unit free from dust.
To prevent damage
• Never place heavy items on it.
• Do not disassemble or reconstruct it.
• Do not spill water or other liquids into it.
(R6/LR6, AA, UM-3)
For R14/LR14, C, UM-2
Remote control
signal sensor
Transmission window