Panasonic CZ-RTC2 Instruction Manual page 18

6. Sleeping Function (Continued)
• If button does not work.
Or if the operation does not start even if
Check the following table.
Display of the remote control unit
Item
(Lighting/fl ashing indication)
1
(for several seconds).
"This function is not available" indication
2
lights up (for several seconds).
Centralized control indication fl ashes
3
(for several seconds).
The sleeping function operation will be cancelled in the following cases:
1: When the unit is operated to stop or change the temperature setting by the other remote control
unit or centralized control device.
2: When the unit is operated to stop or change the temperature setting with the weekly program
function / outing function.
3: When the centralized control unit is prohibited from stopping the unit or changing the temperature
setting.
Note
The temperature setting does not decrease (increase).
Operation under the sleeping function does not fi nish.
The Error indication fl ashes
Trouble
is pressed.
Contents
The clock is not set.
When the operation mode is set to AUTO or
FAN, this function is not available.
The centralized control device is prohibited from
starting/stopping the unit or change the
temperature setting.
Possible Cause/Remedy
The temperature over the upper or lower limit or each
operation mode cannot be set.
Note if you change the time after the sleeping function
started. The operation does not fi nish until it reaches to the
set starting time.
EN-14