Mounting The Unit - Panasonic CY-VM7203N Operating Instructions Manual

In-dash 7" widescreen color lcd monitor
Hide thumbs Also See for CY-VM7203N:
Table of Contents

Advertisement

Installation
(continued)

Mounting the Unit

27
Installation Procedures (When Using Mounting Collar )
Note:
 The car model, installation conditions and combination
of the units used may impose some restrictions on
opening and closing the monitor as well as on the angle
and position to which the monitor can be adjusted.
IMPORTANT
When this unit is installed in dashboard, ensure that there
is suffi cient air fl ow around the unit to prevent damage
from overheating, do not block any ventilation holes on
the unit.
 Flat-Head Screw
(5 mm6 mm)
 Mounting Spring
 Mounting Bolt
(5 mm)
 Power Connector
Insert Trim Plate .
After installation, reconnect
the negative () battery
terminal.
28
CY-VM7203N
Insert the Mounting Collar  into the dashboard,
and bend the mounting tabs out with a
screwdriver.
Fastening the Mounting Collar 
How much to bend the tabs will vary depending
on the car. Bend them with a screwdriver to
fasten the Mounting Collar  securely in the
dashboard.
Dashboard
 Mounting Collar
Tab
Attach the Mounting Springs  to the unit.
Establish the rear connection of the unit.
After fi xing Power Connector , fi x the rear of the unit to
the car body by either method (a) or (b) shown at right.
Insert the unit into Mounting Collar .
Secure the clamp plate of Mounting Collar  to the hook
of Mounting Spring .
Clamp plate
Method for Fixing the Mounting Spring
Two holes of the mounting spring allow you to select between two mounting types as shown below.
(A) Regular Installation Method
A few millimeters of console projecting
 Flat-Head Screw
 Flat-Head Screw
Method for Fixing the Rear of the Unit
(a) Using the Rear Support Strap
(Option)
Fire wall of car
3 mm
Tapping screw (option)
 Mounting Bolt (5 mm)
Hex. Nut
(option)
Rear Support
Strap (option)
(B) Deeper Installation Method
Less projecting
 Flat-Head Screw
 Flat-Head Screw
Caution
 Method (B) is not available in some types of cars.
(b) Using the Rubber Cushion
(Option)
Rear Support Bracket
(Provided on the Car)
 Mounting Bolt (5 mm)
Rubber Cushion (option)
CY-VM7203N
28
29

Advertisement

Table of Contents
loading

Table of Contents