Table of Contents
Advertisement
The vehicle position is not
correctly shown while trav-
eling.
GPS symbol is not dis-
played.
Your car location is not
shown.
No voice guide
Remote control buttons do
not beep.
Map is not displayed
(Screen blank)
60
Problem
Distance compensation is
incomplete.
Vehicle speed pulses are
not correctly connected.
GPS signals cannot be
received due to an obsta-
cle.
GPS antenna cable con-
nection is incomplete.
The system is in map
mode.
Voice guide volume is set
to zero.
The vehicle is off the route.
The vehicle is going back-
wards on the route.
Beep is set to OFF.
Beep was set improperly
during an optional display
unit setup.
Map disc is wet due to con-
densation, scratched, or
dirty.
Possible Cause
Probable Solution
Check if distance compen-
sation has been completed.
(See page 20.)
Read the manual and
check the connection.
GPS signals will be
received when there are
not any more obstacles.
Check GPS antenna con-
nection with the wiring
check screen. (If the cable
is unconnected, read the
manual and check the con-
nection.)
Press the POS button.
Raise the voice guide vol-
ume.
Check the route guide dis-
play on the current position
map. Repeat route search.
Check the direction for your
destination.
Repeat route search.
Turn the beep on.
Set the monitor appropri-
ately for the type of an
optional display unit con-
nected.
Check if the map disc is
wet due to condensation,
scratched, or dirty.
Advertisement
Table of Contents
