Remote Control - Kenmore 580.75051 Owner's Manual

REMOTE CONTROL

Note: The Remote Controller will not operate properly if strong light shines on the sensor window of the Air
Conditioner or if there are obstacles between the Remote Control and the Air Conditioner.
Every time you push button, you will hear a beep from the Air Conditioner.
POWER
• To turn the air conditioner ON, push the button. To turn the air
conditioner OFF, push the button again.
• This button takes priority over any other buttons.
• When you first turn it on, the unit is in cool mode, High fan speed,
Temperature setting at 72 F.
TEMPERATURE SETTING
• This button can automatically control the temperature
of the room. The temperature can be set within a range of
60 F to 86 F by increments of 1 F.
FAN SPEED
•
ON/OFF TIMER
SHUT-OFF TIME
• You will usually use shut-off time while you sleep.
• If unit is running, Timer sets number of hours until shut-off.
• For your sleeping comfort, once Timer is set, the Temperature setting
will raise 2 F after 30 min., and once again after another 30 min.
• Every time you push Timer button, it advances the Timer setting as
follows: 1 Hour 2 Hours
START TIME
• If unit is off, Timer sets number of hours before unit starts.
• Every time you push Timer button, it advances the Timer setting as
follows: 1 Hour 2 Hours
ENERGY SAVER
The fan stops when the compressor stops cooling.
• Approximately every 3 minutes the fan will turn on and
check the room air to determine if cooling is needed.
COOL/FAN
• Everytime you push this button, it will toggle between
COOL and FAN.
OPERATION
etc. 12 Hours maximum.
etc. 12 Hours maximum.
- 11 -
POWER
TEMP
FAN SPEED
TIMER MODE
ENERGY Auto
SAVER Swing