Panasonic SC-PMX3DB Operating Instructions Manual page 19

Others
The picture on the TV
disappears or stripes appear
on the screen.
Remote control doesn't work.
Unit displays
"NO PLAY"
"USB OVER CURRENT ERROR"
"F61"
"F76"
"ERROR"
"VBR–"
"- -:- -"
"MP3 ERROR" or "PLAYERROR"
"UNSUPPORT"
"HI-SPEED CAN'T REC"
The location and direction of the antenna are incorrect. If you are using an indoor antenna,
change to an outdoor antenna ( ➡ page 6).
The TV antenna wire is too close to the unit. Separate the antenna wire of the TV set from
the unit.
Check that the batteries are inserted correctly ( ➡ page 6).
Replace the batteries if they are worn.
Check the content.
Only MP3 format fi les can be played.
The USB mass storage device rating exceeds 500mA. Disconnect the USB device. Turn the
unit off and then back on.
Check and correct the speaker cable connections.
If this does not fi x the problem, consult the dealer.
There is a power supply problem. Consult the dealer.
Incorrect operation performed. Read the instructions and try again.
The unit cannot display the remaining play time for variable bit rate (VBR) tracks.
You plugged the AC mains lead in for the fi rst time or there was a power failure recently.
Set the time ( ➡ page 12).
You have played an unsupported format.
Check the contents.
You have inserted an unsupported device ( ➡ page 14).
You cannot use high-speed recording while using analogue mode. Change to digital mode or
use normal recording.
19