Refueling; Engine Oil - Honda GXV630 Owner's Manual

REFUELING

Recommended Fuel
Unleaded gasoline
U.S. Pump octane rating 86 or higher
Except U.S. Research octane rating 91 or higher
Pump octane rating 86 or higher
This engine is certified to operate on unleaded gasoline with a
pump octane rating of 86 or higher (a research octane rating of 91
or higher).
Refuel in a well ventilated area with the engine stopped. If the
engine has been running, allow it to cool first. Never refuel the
engine inside a building where gasoline fumes may reach flames
or sparks.
You may use unleaded gasoline containing no more than 10%
ethanol (E10) or 5% methanol by volume. In addition, methanol
must contain cosolvents and corrosion inhibitors. Use of fuels
with content of ethanol or methanol greater than shown above
may cause starting and/or performance problems. It may also
damage metal, rubber, and plastic parts of the fuel system. Engine
damage or performance problems that result from using a fuel
with percentages of ethanol or methanol greater than shown
above are not covered under the Warranty.
If your equipment will be used on an infrequent or intermittent
basis, please refer to the fuel section of the STORING YOUR
ENGINE chapter (see page
regarding fuel deterioration.
Gasoline is highly flammable and explosive, and you
can be burned or seriously injured when refueling.
Stop the engine and keep heat, sparks, and flame
away.
Refuel only outdoors.
Wipe up spills immediately.
Fuel can damage paint and some types of plastic. Be careful not to
spill fuel when filling your fuel tank. Damage caused by spilled
fuel is not covered under the Distributor's Limited Warranty.
Never use stale or contaminated gasoline or an oil/gasoline
mixture. Avoid getting dirt or water in the fuel tank.
With the engine stopped and on a level surface, remove the fuel
filler cap and check the fuel level. Refill the tank if the fuel level is
low.
Refer to the instructions provided with the equipment powered by
this engine for refuelling.
Refuel in a well-ventilated area before starting the engine. If the
engine has been running, allow it to cool. Refuel carefully to avoid
spilling fuel. It may be necessary to lower the fuel level depending
on operating conditions. After refueling, tighten the fuel tank cap
securely.
Keep gasoline away from appliance pilot lights, barbecues,
electric appliances, power tools, etc.
Spilled fuel is not only a fire hazard, it causes environmental
damage. Wipe up spills immediately.
11 ) for additional information

ENGINE OIL

Oil is a major factor affecting performance and service life.
Use 4-stroke automotive detergent oil.
Recommended Oil
Use 4-stroke motor oil that meets or exceeds the requirements for
API service category SJ or later (or equivalent). Always check the
API service label on the oil container to be sure it includes the
letters SJ or later (or equivalent).
AMBIENT TEMPERATURE
SAE 10W-30 or 5W-30 is recommended for general use. Use a full
synthetic 5W-30 for starting/operating temperatures between 5°F
( 15°C) and 13°F ( 25°C). Other viscosities shown in the chart
may be used when the average temperature in your area is within
the indicated range.
Oil Level Check
Check the engine oil level with the engine stopped and in a level
position.
1. Start the engine and let it idle for 1 or 2 minutes. Stop the engine
and wait for 2 or 3 minutes.
2. Remove the oil filler cap/dipstick and wipe it clean.
3. Insert and remove the oil filler cap/dipstick without screwing it
into the oil filler neck, then remove it to check the oil level shown
on the dipstick.
4. If the oil level is near or below the lower limit mark on the
dipstick, fill with the recommended oil to the upper limit mark.
5. Reinstall the oil filler cap/dipstick.
Running the engine with a low oil level can cause engine
damage. This type of damage is not covered by the
Distributor's Limited Warranty.
ENGLISH
Synthetic 5W-30
OIL FILLER CAP/
DIPSTICK
UPPER LIMIT
LOWER LIMIT
7