Programming The Remote Control - LG 32LX4DC Owner's Manual

Programming the Remote
Programming the Remote
G The remote control is a multi-brand or universal remote control. It can be programmed to operate most
remote-controllable devices of other manufacturers.
Note that the remote control may not control all models of other brands.
TV VCR CABLE DVD
MODE INFO
POWER
MULTIMEDIA
INPUT EZ PIC
ADJUST SIGNAL EZ SOUND
1 2 3
4 5 6
7 8 9
0
FLASHBK
MUTE FAV
+
SAP TIMER
VOL CH
PIP PIPCH- PIPCH+ SWAP
CC FREEZE PIP INPUT
RATIO
MENU EXIT
PLAY PAUSE STOP RECORD
REW
FF
SKIP
Programming a code into a remote mode
1. Test your remote control.
To find out whether your remote control can operate the component without
HDSTB
programming, turn on the component such as a VCR and press the corre-
sponding MODE button (VCR) on the remote control, while illuminating on
the selected component. Test the POWER button to see if the component
responds properly. If not, the remote requires programming to operate the
device.
2. Turn on the component to be programmed, then press the corresponding
MODE button on the remote control.
3. Press the MENU and MUTE buttons simultaneously for 2 seconds, the but-
ton selected component lights on the remote control. If you don't press any
button for 20 seconds, the button selected component will turn off on the
remote control. At a moment, you have to repeat from step 2.
4. Enter a code number using the number buttons on the remote. When press-
ing the button, the light is blinked at a time. Programming code numbers for
the corresponding component can be found on the following pages. Again,
if the code is correct, the device will turn off.
5. Press the MENU button to store the code. After blinking twice, this code is
stored.
6. Test the remote control functions to see if the component responds proper-
ly. If not, repeat from step 2.
Reference
47