Camco GSD5211 Use And Care Manual page 18

INSTALLATION INSTRUCTIONS
CAUTION
Do not remove the wood base until you are
ready to install the dishwasher. The dishwasher
will tip over when the door is opened.
Check door balance before wood base is removed
Locate the 2 Phillips head countertop mounting
screws wrapped with yellow tape and stuck to the
top or side of the dishwasher. Set aside for use in
Step 10.
Check door balance by opening and closing door.
If necessary latch door and adjust one or both
springs before the wood base is removed.
Step 1. Remove leveling legs and wood base
Move the dishwasher close to the cabinet and lay it
on its back. Remove the four leveling
legs with an adjustable wrench.
Remove and
discard the
wood base.
Do not
"Kick"
wood base
off, damage
will occur.
Step 2. Install Leveling legs
Screw leveling legs back into the dishwasher frame.
The legs should extend approximately 3/4" away
from the frame.
18
Remove the two screws below the access panel and
set aside for reuse. Remove access panel by
backing out the two screws located between the
door and access panel. These screws are secured to
access panel with plastic retainers. The junction box
is located behind the access panel.
Moving spring
hook to rear hole
Figure I
increases spring
tension
Spring hook
MUST be turned
to the outside
Install the 90°
elbow fitting to
the water valve
using thread
seal tape on the
threads. The
water valve
requires 3/8"
NPT fitting
with external
threads. The
opposite end
should fit water supply line. Position the end of the
elbow to face the rear of the dishwasher.
Figure G
Step 5. Position water line and power supply
Position the water supply line and house wiring on the
floor of the opening to avoid interference with base of
dishwasher and components under dishwasher.
Figure H
Step 3. Remove access panel and toekick
Step 4. Install 90° elbow
Figure K
Figure J