LG WF-T8500TP Owner's Manual page 21

U
ser Maintenance Instructions
To Clean the Filter in the Inlet Valve
In case the water supply is impure, check substances like stone or sand in the filter. If the filter is clogged with dirt, water
cannot flow into the washer. Clean the filter regulary. (The figure of power cord and water tap may vary by country.)
Close the tap before turning off the
1
power. Select both hot/cold and then
press the [
remove water remaining in the water
hose completely.
After disconnecting the water
3
supply hose, remove the filter
from the inlet valve by hand
or with tools. Then remove
dirt with a brush, etc.
Caution
Before cleaning the filter, water remaining in the water supply hose should be emptied.
To Clean the Lint Filter
1
Pull out the lint filter from
the tub in the direction
shown below.
Note
• If the lint filter is worn out or damaged, contact a LG Service Center for new one.
• The amount of collected lint depends on the load size and type.
Clean the lint filters when cleaning is needed.
To Clean the Pump Casing
Place a towel on the
1
floor under the drain
pump cap. Excess
water may flow out.
Caution
Check it if water leaks after reassembling. (The gasket is in the cap)
] button to
2 Turn the net inside out
to remove dirt and
rinse it with water.
Turn the cap Remove any foreign
2 3
counter- objects and fluff inside
clockwise and pump casing and from the
pull it out. filter.
Cap
Filter
Turn off the power and
2
disconnect the power
cord.
4
Replace the filter into the water
inlet after cleaning it.
3 Replace the filter to the
original location. Push
the lip of the filter until
a pop sound is heard.
4
Replace the cap. Insert the filter along
the guide ribs inside the pump casing.
Filter must face the guide ribs inside
pump casing and securely turn the cap
clockwise.
Guide rib
21
Filter