Rear Panel - JVC VR-N900U Startup Manual

Getting Started

Rear Panel

1
2
1
[POWER] switch
Switches the power on or off.
Note
• Be sure to press and hold down the [OPERATE] button on
the front panel to shut down the system before switching
off the power supply.
2
[AC IN (120-240V)
Connect to an AC120-240V outlet using the power cable supplied.
3
[RESET]
Resets the system. Press this button when a malfunction occurs.
CAUTION
• Do not press this button in normal circumstances.
4
[AUDIO OUT] terminal (RCA)
Outputs live sound in live viewing mode.
Outputs recorded sound in playback mode.
Note
• Sound will not output in the following cases:
- When playing back still images, when running searches
other than X1, and when playing back frame-by-frame.
- When a menu or search menu is displayed during
playback.
5
[VGA OUT] terminal
Outputs live images, playback images and the menu windows.
6
[SERIAL] terminal
Used to connect the communication control terminals on a
mouse (sold separately), flash memories (sold separately), UPS
(sold separately) and additional disk drives (sold separately).
8
12
13
3 4 5
] power input terminal
11 10 9 8
6 7
7
Connector cover
CAUTION
• Do not remove the connector cover.
8
[LAN 2] connection interface (Intranet network)
For connection to the remote PC network using a LAN cable.
9
[CAMERA CONTROL] terminal
Lets you control the analog cameras.
10
[LAN 1] connection interface (Camera network)
For connection to the IP camera (sold separately) network
using a LAN cable.
11
Signal input/output terminals
For operating the VR-N900U using external alarm signals or
signals received from external devices, or for operating
external devices by outputting signals.
*Diameter of applicable cables: AWG22 to AWG28
12
[VIDEO IN] camera image signal input
terminals 1 to 4
Connect to the video output terminal of the analog camera
(sold separately).
13
[AUDIO IN] terminals 1 & 2 (RCA)
Connect to the audio output terminal of the device from
which audio signals are to be recorded.
CAUTION
• All Audio, Video, and LAN-connectors are not to be
directly connected to Cable Distribution Systems (outdoor
units or between buildings.)