1.2 PROJECTOR SUB 1 and SUB 2 ... . .7 set up and connect PROJECTOR. These advantages and its remarkable ease of use make PROJECTOR a professional Setting up the System .
PROJECTOR the problem you can reset the circuit breaker by simply pressing it. The top unit of the active PROJECTOR system houses a 12” B&C woofer Caution: Always switch the system off before you reset the circuit breaker and a B&C 2" high-frequency driver, both loaded onto 60° x 40°...
Electronically balanced input designed to accept the balanced output signal from the mixing console by way of the THROUGH output of the Projector Mid/High Unit (1= ground, 2= +, 3= -) 2. THROUGH This is a parallel output you can use for routing the LINE signal to...
5°, 10° and 15°. These options let you adjust the MID-HIGH UNITS to match the venue and the given position of the PROJECTOR system. For example, if the system is set on a relatively high platform (one meter or higher), you should select tilt angles of 10° or 15°...
(See notes on flying safety) 2.4 Double Projector System You can add a second Projector system to expand the standard PROJECTOR system setup. Please follow the instructions on setting up the PROJECTOR components SUB 1, SUB 2 and MID-HIGH in section 2.1.
Connect the signal-carrying cable from your mixer (master left/right, line The PROJECTOR should always be switched on last, that means after you out or a similar circuit) to the balanced input on one of the system’s com- switch on all connected devices.
Weight: 65 kg / 132 lbs. 4. PROJECTOR delivers optimum sound, so you should provide it with Dimensions incl. casters : 51 cm x 69 cm x 80 cm / optimum input signals! Noise such as humming is generally caused by (WxHxD) 20.1”...
19.6 kN Starter cable: Steel-wire cable with a length of 270 mm (10-5/8”), a stud, and a carabiner (snap link) for fastening the PROJECTOR MID-HIGH cabinet to Important notes on safety: the fixing point. HK AUDIO item no. G 193 543...