LG BOTTOM FREEZER REFRIGERATOR User Manual page 31

9. CONNECT THE TUBING TO THE
REFRIGERATOR
Removing and Replacing Valve Cover
NOTE: Before making the connection to the
refrigerator, be sure the refrigerator power
cord is not plugged into the wall outlet.
1. Place a compression nut and a
ferrule(sleeve) onto the end of tubing.
2. Insert the tube into the valve and fasten
with wrench as shown in the figure below.
w w CAUTION: Check to see if water dripping
occurs at water line connections.
NOTE: Water valve connector SVC guide
When separating the connector which is
connected in the Valve, press the portion of
and pull the connector with finger as
shown in the the picture
CONNECTING THE WATER LINE
Compression Nut
Ferrule (sleeve)
Tubing
1
10. TURN THE WATER ON AT THE
SHUTOFF VALVE
Tighten any connections that leak.
Reattach the compressor compartment
access cover.
11. PLUG IN THE REFRIGERATOR
Arrange the coil of tubing so that it does not
vibrate against the back of the refrigerator or
against the wall. Push the refrigerator back
to the wall.
12. START THE ICEMAKER
Set the icemaker power switch to the ON
position. The icemaker will not begin to
operate until it reaches its operating
temperature of –9°C or below. It will then
begin operation automatically if the icemaker
power switch is in the I (on) position.
31