Section 3: Altimeter-Barometer Mode; Information Shown In Altimeter; How To Set The Altitude - Oregon Scientific OUTBREAKER RA201 User Manual

Notes:
a) This chronometer works independently with the chronometer in
sailing timer mode.
b) This chronometer can run simultaneously with the sailing timer.
c) If the chronometer is used as a timer, after reset it will go back to
set time in the timer mode. The chronometer could be used as a
stopwatch unless the time display shows 00:00:00.
d) After the countdown timer count to 00:00:00, it will start count
up as a stopwatch automatically.
SECTION 3 ALTIMETER-
BAROMETER MODE
RA201 is equipped with an intelligent barometer that determines
altitude by the built-in sensor with the advanced Bar-compensation
technology, the sensor can also distinguish the differences between
pressure caused by changes in physical altitudes or pressure caused
by weather conditions. This smart distinction eliminates
discrepancies and makes the altimeter reading more accurate than
most of the average devices available on the market.

INFORMATION SHOWN IN ALTIMETER

Five information can be shown in altimeter: clock, altimeter alarm,
temperature, local pressure, and sea level pressure. Press SELECT
to access the information one by one. Refer to Fig 4 to toggle between
the information in altimeter mode.
SELECT
SELECT
Note:
• There is a bar graph at the bottom of the display showing the
altitude history. It will be updated every minute.

HOW TO SET THE ALTITUDE

1. Press and hold SET for two seconds in altitude-clock display to
enter the altitude setting mode.
2. Press SET to toggle between the altitude and resolution setting.
3. Press +/- to increase or decrease the values.
4. Press SET to confirm the setting and toggle to next field and
then quit the setting mode.
11
Altitude alarm Temperature
SELECT
SELECT
Sea level pressure
Local pressure
Fig.4
SELECT