Changing The Batteries - One for All EXTENDER A1 FOR URC-7780 Instructions Manual

IR.exe, they are the only way to perform these functions that maintain the integrity of the device
setup.
Initial Setup
Device
Day/Time
Volume Lock
Language
Advanced Setup
Device Label
There is one proviso. Do not delete or replace the TV device, as the extender expects Device 1 to remain
as TV. You can, of course, change its code if you change your TV.
The two Volume Lock functions may need some explanation in this context. Set Volume Lock lets you
choose the Volume Lock source device and it turns Volume Lock on. This source device then becomes
the default device for the Volume button grouping, as described in section 3. Reset All Volume Controls
turns Volume Lock off, so that the extender uses each device's own setup code for the Volume grouping.
When you have made any desired changes, re-enter the extender by selecting the TV device and pressing
Record.
It is strongly recommended that you then download the new setup to IR.exe and save it. You will find
that the download process exits the extender and leaves it asking you to set the Language, Day and Time.
Do not fear that you have destroyed the extender. This is normal behaviour. After you have made these
entries, you should then be left with the LCD pointing to the TV device. Just press Record to get back to
the extender, with the new settings.
If you delete or replace a device or change a device code, you will probably want to modify the key
moves, macros and special protocol functions that you have created. You need to use IR.exe to do this, in
the same way that you set up the extender in the first place.

12. Changing the batteries

If you are quick, you may be able to change the batteries without losing the current state in the extender.
I would advise changing those on one side first, then the other, rather than taking all four batteries out at
once, but it seems unpredictable whether or not this will work.
If you are too slow, all that happens is that you are returned to the unextended remote and asked to set the
Language, Day and Time. After doing so you will find the TV device selected. Press Record, the LED
will flash four times and you will be back in the extender.
Add Device
Replace Device
Change Device Code
Move Device
View Code
Delete Device
Set Day
Set Time
Set Volume Lock
Reset All Volume Controls
Set Language
Change Device Label
Reset Device Label
Reset All Device Labels
21