Table of Contents
Advertisement
Available languages
Available languages
Dimensions
and Cabinet Requirements
NOTES:
•
13/8"(3.5 cm) diameter opening is required in the sink or
•
Thickness of the sink or countertop must not exceed 13/4 ''
countertop.
(4.4 cm).
C
i
i
'
G
\\\\\
\\
\
\
\\
A. Tank--mounted
vertically
B. Model series KHWG260 faucet
C. 11 ¼" (28.5 cm)
D. 7_"
(19.2 cm)
E. Saddle valve or hard-plumbed
connection
to water supply line
F. 7_" (20 cm)
G. Model/serial
number label
H. 42" (106.7 cm) maximum from 3 prong outlet
to water dispenser tank
I. Cold water supply line
Electrical Shock Hazard
Plug into a grounded 3 prong outlet.
Do not remove ground prong.
Do not use an adapter.
Do not use an extension
cord.
Failure to follow these instructions can result in death,
fire, or electrical
shock.
A 120-volt, 60 Hz, AC-only 15- or 20-amp fused, grounded
electrical supply is required. It is recommended
that a separate
circuit serving only the hot water dispenser be provided. Use an
outlet that cannot be turned on/off with a switch.
Recommended Grounding Method
This hot water dispenser must be grounded. This hot water
dispenser is equipped with a power supply cord having a 3 prong
grounding plug. To minimize possible shock hazard, the cord
must be plugged into a mating, grounded 3 prong outlet,
grounded in accordance with all local codes and ordinances. If a
mating outlet is not available, it is the customer's
responsibility to
have a properly grounded 3 prong outlet installed by a qualified
electrical installer.
It is the customer's
responsibility:
•
To contact a qualified electrical installer.
•
To assure that the electrical installation is adequate and in
conformance
with National Electrical Code, ANSI/NFPA 70 -
latest edition, and all local codes and ordinances.
Copies of the standards listed may be obtained from:
National Fire Protection Association
One Batterymarch
Park
Quincy, MA 02269
Advertisement
Table of Contents
