Advertisement
1. Connect the 2 black wires (C) together using a UL listed wire
connector.
2. Connect the 2 white wires (D) and the green (or bare) ground
wire (of the oven cable) using a UL listed wire connector.
3. Connect the 2 red wires (G) together using a UL listed wire
connector.
4. Install junction box cover.
Install Water Filter
1, Install the water filter near the cold water supply pipe under
the kitchen sink to filter the cold water.
IMPORTANT:
Be sure to allow a minimum clearance of
11/2 '' (3.8 cm) under the filter system for removing the filter
cartridge.
Typical Installation
Configuration
NOTE: For unique installations contact a licensed plumber
Water supply
line to even
Cold water
supply
Hot Cold
water su
2. Attach the supplied water filter mounting ring and screw at
the recommended
location.
3. Attach filter to the mounting ring.
Mounting ring and screw
(3.8 cm) clearance
11/2 ,,
_sssss_ _ y_
_yA_ _
Connect to Home Water Supply
1. Make connection to the cold water supply line.
•
A leak-tight connection to the 1A" copper tubing must be
provided.
•
Check local codes for type of connection required.
•
Copper water supply tubing must be cut with a copper tubing
cutter so the ends are concentric
and without burrs.
NOTE: It is recommended
that the cold water line be soft water.
Connect to Water Filter Inlet (yellow)
NOTE: Use the quick connect stem and/or elbow adapter fittings
in the combination
needed for your installation configuration.
1. Attach the supplied %" to W' stem or %" to W' elbow quick
connect adapter fitting to the yellow water filter inlet
connection by pushing the quick connect fitting past the
o-ring until you hit the backstop.
A. Quick connect elbow adapter fitting
B. Quick connect stem adapter fitting
2=
Connect the copper water supply tubing (not provided) from
the home cold water supply pipe to the quick connect
adapter fitting you just installed on the filter inlet (yellow) side
of the water filter.
3. Pull tube to ensure it is secured.
C
A. Y_" water supply tubing
B. O-ring
C. Backstop
If you need to release tubing:
Push in collet to release tubing. With collet held in, pull tubing
straight out.
A
//'
A. Collet
_sssss_
Connect to Water Filter Outlet (blue)
1. Attach the supplied %" to %" stem or %" to W' elbow quick
connect adapter fitting to the blue water filter outlet
connection by pushing the quick connect fitting past the
o-ring until you hit the backstop.
2. Connect another piece of copper water supply tubing to the
quick connect adapter fitting you just installed on the filter
outlet (blue) side of the water filter.
Advertisement
