LG F1409TDS Owner's Manual page 30

T roubleshooting guide
Symptom
• Water supply is not adequate in area
• Water supply taps are not completely open.
• Water inlet hose(s) are kinked.
• The filter of the inlet hose(s) are clogged.
• Drain hose is kinked or clogged.
• The drain filter is clogged.
• Load is too small.
• Load is out of balance.
• The appliance has an unbalance detection and
correction system. If individual heavy articles are
loaded (ex. bath mat, both robe, etc.), this system
may stop spinning or even interrupt the spin cycle
altogether.
• If the laundry is still too wet at the end of the cycle,
add smaller articles of laundry to balance the load
and repeat the spin cycle.
• Water overfills due to the faulty water valve.
• Water level sensor has malfunctioned.
• Over load in motor.
• Water leaks
• The washer experienced a power failure.
Possible Cause
• Is the door opened or not
completely closed?
Solution
Check another tap in the house.
Fully open tap.
Straighten hose(s).
Check the filter of the inlet hose(s).
Clean and straighten the drain hose.
Clean the drain filter.
For more detailed information,
please refer to "The drain pump filter"
on page24
Add 1 or 2 similar items to help
balance the load.
Rearrange load to allow proper
spinning
Close the door completely.
❋ If "
"is not released, call for service.
Unplug the power plug and call for service.
Close the water tap.
Unplug the power plug.
Call for service.
Call for service.
Restart the cycle.
29