Denon AVR-X1000 Owner's Manual page 154

Contents Connections
Symptom
DTS sound is not output.
Dolby TrueHD, DTS-HD, Dolby Digital
Plus audio is not output.
Dolby PLg mode or DTS NEO:6 mode
cannot be selected.
Audyssey MultEQ® XT, Audyssey
Dynamic EQ® and Audyssey Dynamic
Volume® cannot be selected.
"Restorer" cannot be selected.
Front panel Display
Playback
• Check that the digital audio output setting on the connected device is set to "DTS".
• Set "Decode Mode" on the menu to "Auto" or "DTS".
• Make HDMI connections.
• Check the digital audio output setting on the connected device. On some devices, "PCM" is
set by default.
• It cannot be selected when "None" is set for "Speaker Config." – "Center" and "Surround".
• These cannot be selected when using the headphones.
• These cannot be selected when you have not performed Audyssey® Setup.
• Switch the sound mode to other than "DIRECT".
• These cannot be selected when using the headphones.
• Check that an analog signal or PCM signal (Sample Rate=44.1/48 kHz) is input. For playback
of multichannel signals such as Dolby Digital or DTS surround, "Restorer" cannot be used.
• Switch the sound mode to other than "DIRECT".
Rear panel
Settings
Cause / Solution
154
Remote
Tips Appendix
Page
30, 31
Index
–
124
–
134
–
125
91
–
113
91