Shure M92 LT Specifications

M I C R O P H O N E S A N D E L E C T R O N I C C O M P O N E N T S
AREA CODE 3121866-2200
.
CABLE: SHUREMICRO
I
I
TWX: 9 1 0 - 2 3 1 - W 4 8 TELEX: 7 2 - 4 m 1
1
SPECIFICATIONS
Stylus: 10 x 18p (.0004 x ,0007 in.), biradial elliptical diamond tip. Tan grip.
Frequency Response: 20 to 20,000 Hz
Output Voltage (at 1,000 Hz, 5 cmlsec peak velociiy): 4.0 mV per channel
Channel Balance: Within 2 dB
Channel Separation (minimum): 20 dB at 1,000 Hz
Optimum Load: 47,000 ohms resistance in parallel with 200 to 300 picofarads total capacitance per
channel. Load resistance can be up to 70,000 ohrns with almost no audible change in frequency
response. Total capacitance includes both tone arm wiring and amplifier input circuit.
Inductance: 700 millihenries
DC Resistance: 1550 ohms
Tracking Force: 1.25 grams optimum; 1.5 grams maximum
Net weight: 6 grams
Upgrade Replacement Stylus: N94LT with 10 x 18p (.0004 x .0007 in.), biradial elliptical diamond tip.
Dark Blue grip.
STYLUS CLEANING
Use a soft brush with an alcohol-distilled water
solution or Shure Stylus Cleaning Solution. (See
your dealer and ask for the Shure SK-I, Stylus
Cleaning Kit.) Brush only from back to front as
shown in Figure 1. Other commercial cleaning
IT1
solutions may cause stylus damage.
STYLUS REPLACEMENT
Place the Technics Ltnear Tracking arm in a con-
STYLUS
STYLUS REPLACEMENT
venient posttion as follows. FIGURE 1 FIGURE 2
1. With the lid closed, use the "manual" mode to move the arm to approximately the center of its
travel.
2. Make certain the cartridge is cued "up" (raised off the record), and press the Off-On switch "Off."
3. Raise the lid.
Replace the stylus as shown in Figure 2. Always hold the stylus only by the plastic grip, take care not
to touch or damage the shank or diamond tip.
Copyright 1982, Shure Brothers
I n c .
27A1768 (BA)
Printed
i n
U.S.A.