Overview Of Programmes - Bosch WAS28462GB Instruction Manual

Individual settings
Options buttons
The spin speed and temperature can be changed before and during the selected programme. The effects depend on
the programme progress.
(Temperature °C)
You can change the displayed washing temperature. The maximum washing temperature that can be selected depends
on the programme that has been set.
(Finished in)
When you select the programme, the relevant programme duration is displayed. You can delay the start of the programme
before it begins. The "Finished in" time can be set in increments of one hour up to a maximum of 24 hours. Press the
(Finished in) button repeatedly until the desired number of hours is displayed (h = hour). Press
(Spin speed in rpm) / (Rinse hold = no final spin)
You can change the spin speed shown or select
final rinse, - - - appears in the display panel). You can change the spin speed shown. The maximum selectable spin
speed depends on the model and on which programme is currently selected.
Additional functions
and overview of programmes, page 7
Speed Perfect For washing in a shorter time with a washing result comparable to that of the standard pro-
gramme. Maximum load
Eco Perfect For saving energy with a washing result comparable to that of the standard programme.
Special spin sequence with subsequent fluffing. Gentle final spin at reduced speed.
Reduced Ironing Residual moisture in the laundry is increased slightly.
Aqua Plus
Additional rinse cycle. Increased water level. For areas with very soft water or for further
improving the washing result.
Childlock
You can lock the washing machine to prevent the functions you have set from being changed
in the display panel inadvertently.
ON/OFF: after the start/end of the programme, press and hold
5 seconds.
Note: The childlock can remain activated until you wish to start the next programme, even after
switching off the machine.
Then you can deactivate the childlock before starting the programme and activate it again as
necessary once the programme has started.
Note:
– The symbol is lit: Childlock active.
– The symbol flashes: Childlock active and then the programme selector is altered.
To prevent the programme from stopping, turn the programme selector back to the original
programme, the
Add laundry
+ If you want to add additional items of laundry after the programme has started, press the
Start/Reload button. The machine checks whether adding laundry is possible.
in the display panel
+ are lit: Adding laundry is possible.
flashing: Wait until
Note: Only open the washing machine door when both the
: It is not possible to add laundry.
Note: for safety reasons, the washing machine door remains locked when the water level and/
or temperature is high, or during spinning.
To continue the programme, press the
Energy saving mode
If the washing machine is switched on and is not operated for several minutes before the programme starts or at the
end of the programme, the display panel light goes out and the
Press any button to turn the light back on.
(Rinse hold = no final spin, laundry remains in the water after the
Overview of programmes, page 7.
Start/Reload for approx.
symbol is lit again.
+ are lit.
+ symbols are lit.
Start/Reload button.
Start/Reload button flashes.
Individual settings
Signal
1. Activate the
setting mode for
signal volume
Start/Reload.
2. Set the
volume for .. .
Start/Reload
To start the programme or to subsequently load additional laundry, and to activate/deactivate the childlock.
5
•
1 step, the Press and
Set to
display panel hold
lights up
Button signals
Information signals
skip
Set the
Set the 1 step
volume*
volume*
* you may need to select the function several times
1 step,
+
release
•
Set to
6