Viking VMOC205 Installation Instructions

I NSTALLATIO
INSTRUCTIO
PROFESSIONAL SERIES
CONVECTION MICROWAVE BUILT-IN TRIM
Retain for Future Reference
KIT
VIKING RANGE CORPORATION
111 Front Street
Greenwood, Mississippi 38930 USA
(662) 455-1200
iMPORTANT - PLEASE READ AND FOLLOW
• Before beginning, please read these instructions completely and carefully.
• Be sure to DISCONNECT THE PLUG of the microwave oven from the electrical outlet before installing the built-in trim kit.
Remove the turntable from the oven cavity.
• Because the kit includes metal parts, caution should be used in handling and installation to avoid the possibility of injury.
• Do not remove permanently affixed labels, warnings, or plates from the product. This may void the warranty.
• Please observe all local and national codes and ordinances.
• The installer should leave these instructions with the consumer who should retain for local inspector's use and for future
reference.
THIS BUILT-IN TRIM KIT IS DESIGNED FOR USE ONLYWITH VIKING CONVECTION MICROWAVE OVENS SPECIFY-
ING BUILT-IN TRIM KIT VMTK275/276, VMTK305/306 OR VMTK365/366 ON THE RATING LABEL ON THE BOTTOM
FACE PLATE OF THE OVEN CAVITY.
IF YOUR LOWER CONVENTIONAL OVEN IS NOT LISTED IN THE USE AND CARE MANUAL OF THE MICROWAVE
OVEN, THEN DO NOT INSTALL THE MICROWAVE OVEN ABOVE IT OR IN ANY AREA WHERE HEAT AND STEAM
ARE GENERATED; FOR EXAMPLE, NEXT TO OR ABOVE A CONVENTIONAL RANGE.
PARTS iNCLUDED iN THE VMTK KITS
1) Front Frame Assembly 2) Bottom Duct Assembly 3) Screw A (1/2" length) 4) Screw B (1 3/4" length)
QTY 1 QTY 1 QTY 10 QTY 4
5) Screw C (1 3/16" length)
QTY 2
6) Duct A (1) 7) Duct A (2) 8) Duct A (3) 9) Duct B 10) Duct D
QTY 1 QTY 1 QTY 1 QTY 1 QTY 1