Electric Dryer Electrical Connections; Leveling - Whirlpool CGM2743BQ Installation Instructions Manual

ELECTRIC DRYER ELECTRICAL CONNECTIONS (FOR
U.S.A.
ONLY)
Connecting 3=Wire Connection: Optional
Use for direct wire or power supply cord where Ideal codes
do not permit connecting cabinet=ground conductor to
neutral wire.
Connecting Neutral Wire
1. Remove center terminal block screw (A). Also remove
neutral ground wire (B) by removing green external ground
conductor screw (C).
3. Connect remaining wires under outer terminal block screws
(F). Tighten screws.
!
F
2. Connect neutral ground wire (B) and neutral wire (white or
center wire) (D) of power supply cord/cable under center
terminal block screw (A). Tighten screw.
_A
4. Connect a separate copper ground wire (G) under the green
external ground conductor screw (C) to an adequate ground.
Finally, reinstall terminal block to dryer rear panel. Secure
cover with hold-down screw.
LEVELING
Leveling your dryer properly reduces excess noise and vibration.
Excessive Weight Hazard
Use two or more people to move and install dryer,
Failure to do so can result in back or other injury. Not Level LEVEL Not Level
1. Remove cardboard from beneath dryer. Place a level on top
edges of dryer, checking each side and front. If not level,
tip dryer and adjust legs up or down as shown in Step 3,
repeating as necessary.
£
22