Technical Specifications - Graphics - HP dx7300 Overview

QuickSpecs

Technical Specifications - Graphics

Integrated Graphics
Media Accelerator 3000
1
Resolutions Supported
1 Modes listed are supported with a single active display. The supported mode list for multiple active displays is a subset of this list.
Not all modes will support video playback and some supported modes may use software MC (motion compensation) rather than
hardware MC. Not all modes will support 3D acceleration depending on the system configuration (e.g., resolution selected, size of
frame buffer, number of installed memory modules, etc.).
NOTE: Other resolutions and refresh rates may be selectable but are not recommended.
3D/2D Controller
VGA Controller
Bus Type
RAMDAC
Memory
Controller Clock Speed
Overlay Planes
Maximum Color Depth
Maximum Vertical
Refresh Rate
Multi-display Support
Graphics/Video API
Support
Resolution
640 x 480
800 x 600
1024 x 768
1280 x 1024
1600 x 1200
1920 x 1080
1920 x 1200
1920 x 1440
2048 x 1536
DA - 12583 Worldwide — Version 15 — September 19, 2007
Microsoft DirectX® 9 based with support for Pixel Shader 2.0, 4:1 anisotropic
filtering, Gaussian texture filtering, shadow maps, volumetric textures,
double-sided stencil buffers, and 4 pixel pipes.
Integrated
PCI Express™ x16 (If an external graphics card is installed in a PCI slot, the
internal graphics can be enabled or disabled using the system's BIOS setup
utility. If an external graphics card is installed in the PCI Express™ slot, the
internal graphics cannot be enabled).
Integrated, 400 MHz
Graphics memory is shared with system memory. Graphics memory usage
varies depending on the amount of system memory installed and system load.
8 MB is pre-allocated for graphics use at system boot time. Additional memory
is allocated for graphics as needed using Intel's Dynamic Video Memory
Technology (DVMT), to provide an optimal balance between graphics and
system memory use.
System memory equal or greater than 512 MB
8 MB pre-allocated + 248 MB DVMT = max frame buffer of 256 MB
400 MHz
Single overlay support with 5x3 filtering
32 bits/pixel
85 Hz at up to 1920x1440, 85 Hz at 2048x1536. Varies with mode and
configuration. See table below.
Support for one CRT via the motherboard's VGA connector. Support for an
additional DVI-D display via the optional DVI ADD2 card. Dual independent
displays and dual synchronous (Twin or Clone mode) displays are supported.
Microsoft DirectX®9, DirectXVA®, VMR9, GDI/GDI+; OpenGL® 1.4.
Analog Monitor
85
85
85
85
85
85
85
85
85
HP Compaq dx7300 Business PC
Maximum Refresh Rate (Hz)
Digital Monitor
60
60
60
60
60
60
60
60
60
Page 26