Honda 2006 CB600F Owner's Manual page 162

5. Check rear axle alignment by making
sure the chain adjuster index marks ( )
align with the index lines ( ) on both
sides of the swingarm.
Both marks should correspond. If the
axle is misaligned, turn the right or left
adjusting nuts until the marks are
aligned and recheck chain slack.
6. Torque the rear axle nut to:
65 lbf·ft (88 N·m , 9.0 kgf·m)
If a torque wrench is not used for this
installation, see your Honda dealer as
soon as possible to verify proper
assembly. Improper assembly may lead
to a loss of braking capacity.
7. Tighten the adjusting nuts lightly. Then,
while holding the adjusting nuts with a
wrench, tighten the lock nuts.
4
5
8. Recheck drive chain slack (page
Lubrication
Refer to Saf ety Precautions
Lubricate every 500 miles (800 km) or
sooner if chain appears dry. Lubricant:
SAE 80 or 90 gear oil
Servicing Your Honda
Drive Chain
149 ).
on page 82 .
(cont'd)
153