Advertisement
II_ Slideinnerwindowsashfirmly against s ideofthecabinet. M akesurenotto peel t hesealstrips fromthewindow
trackandcabinet s idechannels. If thepanel f ramedoesnotfit snugly totheinner window sash, s ecure thepanel f rame
tothesashwith#8x 3/4"self-threading screws. Usethepartially plugged holes inthepanel f rame.Drill118" p ilot
holes forthescrews.
_Hook the safetybracketoverthebaseoftheunitandfastenittothefrontoftheplatform assembly (FIG.18). Use
a #8-32 x 3/4"self-threading screw.
NOTE: T hebracket p revents m ovement of theairconditioner (either i nor out)aftercompleting theinstallation.
_Stuff
the windowsashsealbetween thevertical sashandthewindow glass, a sshown (FIG.19).
_Use
thewindowlockingbrackettolocktheinnerwindow sashtothebaseoftheouterwindow sash(FIG.19).
Useone#8x 3/4"screw, o r#8-32x 3/4"self-threading screw. ( Drill118" p ilothole).
_To
replacethe frontfirstreconnect thecoupler p lugs, m aketheexhaust c ontrol p ositioned t hrough thefrontin
theproper location. G ently pushthefrontintoposition onthecabinet. I t should clickintoplace. T henreplace the
retaining s crews thatholds thepanel i n place. D ONOTpushor pull t hefrontpanel l ouvers.
Insttall s afetybracket
FIG.18
window sashseal
FIG.19
Window
locking
safetybracket
bracket
Alternate
Window
Jamb Applications
To install in windows having no flanges or wood stops on the top and side jambs, the channels and panel frame must
fit against a matching flange (or 1/16" max. thick angle) attached to the window jambs. FIG.20A shows this angle
installed. FIG.20B & FIG.20C show alternate treatments. On the sash side of the opening, the leading corner of the inner
sash becomes the flange. You can purchase the angle strip locally.
FIG.20A
FIG.20B
FIG.20C
Add angle to wood stop
Add wood as shown
Add 16- or 18- gage angle
Platform
Assembly
FIG.21
Installing
the Unit in a Casement
Window
• Open the window the maximum amount to allow for clearance of the cabinet.
The crank handle should be removed to allow the platform to be fastened to
the jamb. If the window cannot open far enough (more than 15-1/2 ) for the
cabinet to clear the window, remove the window entirely by drilling out the
rivets. Bolts can serve as the pivots in the feature.
o To avoid crank handle and window clearance problems, the unit can be
installed in a stationary sash section. However the horizontal mullion and
the 2 glass panels must be removed before installation.
_
Attach support
brace to platform as shown (FIG.21). Use the adjustment bolt
and hex flange nut to complete the assembly. Choose the slot and adjustment bolt
hole location that will create a 45 degree angle between the platform and support
brace. Try the assembly in the window to determine if the platform will rest properly,
and allow the proper slope (3/16" lower on outside).
1/4" (6mm) HEX
FLANGE NUT
Advertisement
