18,500 -25,000 btu window heat / cooling unit (19 pages)
Summary of Contents for Crosley CAHE25ER12
Page 1
installation instructions For Heavy Duty (FAS Models) Median (FAM Models) Air Conditioners Please read ALL instructions before installing.Two penple are recommended to install this product.If a new electrical outlet is required,have the outlet installed by a qualified electrician belbre installing unit, See#5 ill Preliminary hlstruetions SAFETY...
4. CHECK FOR ANYTHING THAT COULD BLOCK Tools Required AIRFLOW- check area outside of window for things such as shrubs, lrees, or awnings. Inside, be sure a large flat blade screwdriver furniture, drapes, or blinds will not stop proper air flow. tape measure adjustable wrench or pliers...
Page 3
Window Mounting Remove Chassis install Top Angle and Side Bracket 1. Pull down front panel and remove filter. (See F[G. 1). 1. Attach lbam gasket to top angle above holes as 2. Lift front upwards and place to one side. shown in FIG.
Page 4
|nstaR Support 3. Inserl lop and bottom Iegs of window filIer panel frame Bracket into channel in the to angle and bottom rail. Do both sides. I. Hold each support bracket flush against outside &sill, 4. Insert washer head locking screws (2) into holes in and tight to bollom of cabinet as shown below.
Page 5
install Chassis into Extend Window Filler Cabinet and install Panels Front to Unit 1. Carefully raise windnw to expose filler panel locking 1. Lift air conditioner and carefully slide into cabinet screws. Loosen screws so filler panels slide easily. leaving 6"...
Thru-The-Wall Installation NOTE: (onsult local building codes prior to installation, Carefully measure and cut an opening with the following or a qualified carpenter. dimensions depending on your model. See FIGS. land 2. WIDTH "X" inside model width plus twice the thickness Select Wall Location...
Page 7
NOTE: If wall thickness is 8-1/'2" o1"more, add alumhmnl flashing o_er bottom of flame opening to assure no v_ aler F1G.2 can enter area between inner and outer wall. I"LONG \VOOD SCREW Refer to Step 4 of Window Mounting for assembly of support brackets.A wooden strip nailed lo the ou/side wall should be used in conjunction with sill support...
OPTIONAL:Caulking a ndinstallation o f trimoninterior wallmaybedone. Y oucanbuywood fromyourlocal l umber o1" hardware supply. Onthe outside, caulk openings around k_p and sides of cabinet, and all sides of wood sleeve to the opening. NOTE: See Step 7, item 3 of Window Mounting Instructions for bottom rail seal location.
This manual is also suitable for:
Cae25esr12Cae25esr11Cae25esr15Cahe25er14Cae25esr16Cahe25er13...
Show all
Cahe25er15Cae25esr13Cahe25er16Cae29er11Cae2Fas seriesFam series