Table of Contents
Advertisement
OWNER'S MANUAL
Advanced Setup
This is normally done by the installer at initial installation.
Enter advanced setup by adjusting the program switch to
SET. When the clock is flashing, press NEXT for 5 seconds.
Do not release the button until this screen appears.
I
NEXT
6
NEXT
L I
Yes
NEXT
F
Adjust the program switch to OFF or RUN to exit
Advanced Setup.
MODEL TSTAT0712
Use these buttons to
adjust the deadband
from 1 to 6 degrees.
Use these buttons to
adjust the cycles/hour
from 2 to 6.
d=no limit (zoning)
d1=d+no compressor
lockout.
Step only
Select YES to have the
appears
backlight always on, or NO
if connect-
to turn off the backlight 8
ed to 24
seconds after a button press.
volt power
Use these buttons to select
thermostat operation in
degrees C or F.
If degrees C is selected two presses of the Up or Down
buttons will be required to change the setpoint.
Page 17
Advertisement
Table of Contents
