Scsi Id Setting - Sony SDX-S300C Operator's Manual

SCSI ID Setting

The SCSI ID is set by the rotary switch on the rear panel. Press the + or –
buttons to change the selected SCSI ID.
As shipped from the factory, the SCSI ID is set to 0. Press the switch buttons,
if necessary, to select the SCSI ID number you require. SCSI IDs above 9 are
displayed as A to F (hexadecimal). Usually 7 is reserved for the host adapter
ID, and should not be selected for other devices.
Precautions
• The SCSI ID must be of each device must be different (unique) from the
IDs of other peripherals on the SCSI bus.
• As shipped from the factory, SCSI parity is enabled and Term power is ON.
The internal terminator is disabled, so make sure a terminator is connected
to the end of the SCSI bus before use.
• Before changing the SCSI ID setting, be sure to turn off the power with the
POWER switch on the rear panel.
11
Part 2 Preparation