BMW MINI Owner's Manual page 144

Bmw mini
Hide thumbs Also See for MINI:
Table of Contents

Advertisement

MINI MOBILITY SYSTEM
Pumping in liquid sealant
1. Shake the filling canister
2. Screw the filling hose onto the filling
canister
3. Unscrew the dust protection cap from
the valve of the defective tire
4. Screw out the valve core with the valve
remover. The valve remover is located in
a package with the filling hose.
Place the valve core and valve
remover only on clean
5. Remove the cap from the filling hose
6. Push the filling hose onto the tire valve
142
*
7. Hold the filling canister with the cap
down and squeeze.
Squeeze the entire contents of the canis-
ter into the tire
8. Remove filling hose
9. Screw valve core into the tire valve with
the valve remover.
In the event of a lost or dirty valve
core you will find another valve core
in a package with the filling hose.
Please remember that the liquid canister
must be replaced every four years if the
equipment has not been
surfaces.<
Online Edition for Part no. 01 41 0 014 845 - © 08/07 BMW AG
Reinflating the tire
1. Screw hose 1 with manometer onto the
used.<
tire valve
2. Connect plug 3 to the cigarette lighter
socket in the vehicle interior, refer to
page
90
3. Ignition key in position 1:
switch on compressor 2
4. Inflate the tires to at least 26 psi/
180 kPa, but not to more than 36 psi/
250 kPa.
To check the current air pressure, shut
off the device for a short time.
the device will overheat and possibly be
damaged.<
Do not run the compressor for
longer than 6 minutes, otherwise

Hide quick links:

Advertisement

Table of Contents
loading

This manual is also suitable for:

Mini convertible

Table of Contents